john2116 |
Fri May 13, 2005 5:07 pm |
|
i am putting togeather my 1600 motor. after i torque down all the nuts on my case the crank does not turn freely. i then took the case appart to check the bearings...none of them were pinched. what else could be the problem? what should the 6 main bolts be torqued to? |
|
Russ Wolfe |
Fri May 13, 2005 5:29 pm |
|
Your case is either warped, or one of the small dowls that keep the bearings from spining is misaligned.
Pull it back apart. |
|
TWD |
Fri May 13, 2005 6:31 pm |
|
Wrong bearings? |
|
john2116 |
Fri May 13, 2005 9:18 pm |
|
i torqued the nuts in the wrong order...thanks folks |
|
Powered by phpBB © 2001, 2005 phpBB Group
|