| chipmcluk |
Sat May 21, 2005 11:34 am |
|
| Just did a straight axle conversion on my bus, but after swapping the nose cones and hockey stick and putting it back in the bus, it wont shift. Shift lever is stuck and wont go in or out of any gear, any ideas?? |
|
| rizzag |
Sat May 21, 2005 11:36 am |
|
| sounds like you didnt have it in neutral when you swapped the nosecone and you put the selector in a gear it was not in. |
|
| chipmcluk |
Sat May 21, 2005 11:48 am |
|
| Any idea how to fix it?? |
|
| rizzag |
Sat May 21, 2005 11:52 am |
|
chipmcluk wrote: Any idea how to fix it??
*IF* thats the problem, it all comes back out. |
|
| rizzag |
Sat May 21, 2005 11:56 am |
|
did you set it up like this?
Hazetguy(2005)
Hazetguy(2005) |
|
| chipmcluk |
Sat May 21, 2005 12:01 pm |
|
| you know, i cant recall. No way to tell without pulling it all out again huh? |
|
| rizzag |
Sat May 21, 2005 12:02 pm |
|
| nope... |
|
| type2sr4me |
Sun May 22, 2005 10:51 am |
|
| I just did that in my bus and I had to take it out. Not too bad I guess. about 1 hrs work. |
|
| BugEyed_1978 |
Mon Feb 28, 2011 11:11 pm |
|
| hey i know this is an old post but i was wondering if the pis show the proper placement of ever thing? |
|
| bill may |
Tue Mar 01, 2011 6:35 am |
|
BugEyed_1978 wrote: hey i know this is an old post but i was wondering if the pis show the proper placement of ever thing?
even in Canada the forks get set even like those in picture. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|