kustomkat1950 |
Wed May 25, 2005 4:07 pm |
|
okay, so i did a valve adj. sucks I hate them , still do Ill pull teeth rather than do a valve job. so what should my timing marks be at? I have a degree pulley so that makes it easy. 5-7 BTC or right on the 0??? Im getting misreadings on my many adjustment. its a 1776 w/dual kadrons. usually runs like a raped ape. then again, it has been 110+ out here temp wise..... |
|
karfer67 |
Wed May 25, 2005 4:09 pm |
|
i would say 7 but try 5 first to be safe. too much and it will heat up quickly. boy and i am bitching about the heat here in sac town today it is 101 at the moment. |
|
kustomkat1950 |
Wed May 25, 2005 4:52 pm |
|
wow that would be nice. Last year it was 132 out where I work in the middle of the desert. thanks for the speedy reply..... |
|
bill may |
Thu May 26, 2005 7:37 am |
|
which distributer? |
|
kustomkat1950 |
Thu May 26, 2005 7:57 am |
|
hey bill, its a 009 w/points |
|
Powered by phpBB © 2001, 2005 phpBB Group
|