| vw_mike@hotmail.com |
Fri Jul 08, 2005 2:14 pm |
|
im in the prossess of lowering the rear of my 57. I knocked the spring plates of the rests and measured the degrees on both sides. I left them in. when I checked my car the next day my buddy had knocked the springs plates all the way off and out. the springs came out of the inner splines.
I only wanted to lower the car one notch on the inner splines.
does anyone have advice on were I should start in getting these back together right.
thanks..... |
|
| RareAir |
Fri Jul 08, 2005 3:17 pm |
|
vw_mike@hotmail.com wrote: ....my buddy had knocked the springs plates all the way off and out....
What are friend for. Get ready for some trail & error fitting those torsions to sit the same on both sides of the car. Very tedious, but it can be done. |
|
| doubledoor |
Fri Jul 08, 2005 6:54 pm |
|
| If you put the plates in so they are just touching the bottom of the torsion stops that is about one notch. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|