| bigbore |
Tue Jan 10, 2012 8:17 pm |
|
| Taking the ring off of that type of diaphragm should be fine. the fingers are raised up at the tips just under the ring right? That trany mount adaptor should be ok I have never run one but I have used those urethane mounts and they do transmit engine some noise and vibration if that is a concern. |
|
| Vanapplebomb |
Fri Mar 16, 2012 12:10 pm |
|
Is there any good way to judge the condition of seals on the transmission, especially the input shaft and drive flange seals?
I got the transmission without oil, and I really don't want to fill it up and then find out they are shot. |
|
| bigbore |
Fri Mar 16, 2012 12:16 pm |
|
Vanapplebomb wrote: Is there any good way to judge the condition of seals on the transmission, especially the input shaft and drive flange seals?
I got the transmission without oil, and I really don't want to fill it up and then find out they are shot.
The only way is to replace them and your sure. |
|
| Micropassatman |
Fri Mar 16, 2012 12:18 pm |
|
bigbore wrote:
The only way is to replace them and your sure.
X2 |
|
| Vanapplebomb |
Fri Mar 16, 2012 10:30 pm |
|
| Think I should replace the nose cone seal and bushing too? |
|
| bigbore |
Fri Mar 16, 2012 10:39 pm |
|
Vanapplebomb wrote: Think I should replace the nose cone seal and bushing too?
if they are bad and I have found most of the time they are bad along with the hockey stick you can get both bushing ,seal and the hockey stick new from Weddle Industries for right round 30.00. If its a 091 6 rib trany there is no bushing to ware out there is pin bearings and I have never seen them ware out so just replace the seal. |
|
| Vanapplebomb |
Sat Mar 17, 2012 12:23 pm |
|
Yup, it's a type 1 so shes got the bushing. Alright, I guess I will get new seals all the way around. Thanks for your help guys.
Alright, cross shaft stuff...
So I got the cross shaft bushing set that was for non split cases threw 1972. Well, apparently my 72 was a late model that has the 20mm cross shaft, not the earlier 16mm one that the kit was made for. I could just buy a different kit, but honestly, 10 bucks a kit, 5 bucks shipping...not worth it. I could just as easy turn a bushing for it out of bronze. I know the internal dimension has to snugly fit the 20mm shaft, but what about the outer diameter of the bushing? Does anybody have any clue or can measure what that is? |
|
| Vanapplebomb |
Tue Mar 20, 2012 4:23 pm |
|
About the hockey stick...
I have to say that it has zero in and out play when it is in gear, but it has some rotational slop...is it normal for the stick to be able to rotate a few degrees when twisted? |
|
Powered by phpBB © 2001, 2005 phpBB Group
|