| Odamnimgood |
Thu Apr 20, 2006 8:26 pm |
|
| i ordered a 200mm clutch kit to fit the DP 1600cc motor i bought, im pretty sure its a later model. the flywheel has a groove right where the clutch would bolt on with the holes matching perfect. The problem is that the difference in that grove and the rest of the flywheel is what is keeping me from bolting on the clutch... do i have an early 200MM clutch with the newer model flywheel, or vice versa?? the gap is not a lot at all maby 4-5 mm. Whats wrong with this setup?? |
|
| MURZI |
Thu Apr 20, 2006 8:32 pm |
|
A pic would be good. You probably have a 180mm flywheel.
180mm is 7 inches, a 200mm is almost 8 inches. Measure it and see.
MURZ |
|
| UncleBob |
Fri Apr 21, 2006 6:31 am |
|
Or, count the teeth on your flywheel.
130=12V
109=6V |
|
| Odamnimgood |
Fri Apr 21, 2006 7:50 am |
|
| its a 12v flywheel, and i ordered a 12 v starter, but this clutch housing just doesnt match perfect against the flywheel |
|
| UncleBob |
Fri Apr 21, 2006 8:14 am |
|
You mean the pressure plate doesn't match the flywheel?
Pictures would help. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|