honky |
Fri Sep 22, 2006 4:22 pm |
|
I installed a anti rattle bushing in my steering column.
There was alot of play and this got rid of about 90% of it.
Pictures below
The new bushing is the white ring.This was a easy install
Remove the wheel,turn signal switch and wiper switch and slide the bushing over the column into place inside the existing bearing
http://albums.photo.epson.com/j/ViewPhoto?u=4174492&a=32307634&p=74808596
http://albums.photo.epson.com/j/ViewPhoto?u=4174492&a=32307634&p=74808597
http://albums.photo.epson.com/j/ViewPhoto?u=4174492&a=32307634&p=74808598 |
|
John M. |
Sat Sep 23, 2006 10:04 am |
|
Nice! |
|
dodge this one |
Fri Sep 29, 2006 12:15 am |
|
What is the factory part # for this item? I'm assuming its a dealer only? I need a new steering column bushing and was told its a dealer only part. My wheel is so bad if I push down on any part while turning my horn starts going off :P Thanks |
|
honky |
Fri Sep 29, 2006 5:16 am |
|
Bushing,Steering Column-anti rattle
Part# 111-535D
Got mine from West Coast Metric
about 6.00$
Good Luck |
|
Powered by phpBB © 2001, 2005 phpBB Group
|