| rlmartinez |
Wed Dec 27, 2006 9:29 pm |
|
Hello All,
I am looking for info on bee hive taillights, what kind of mounting hardware is necessary what size hole is needed for running wires and the like. A pic of light with hardware would be great.
Thanks Ron |
|
| TC/TeamEvil |
Thu Dec 28, 2006 7:52 am |
|
This is the place to go:
http://www.356registry.org/
If you own a 356, you have to join up. Cheap, easy, cool magazine and more tech information than you ever need. Just no "forum" for some ol' skool reason. Too bad . . . |
|
| rlmartinez |
Thu Jan 04, 2007 8:47 pm |
|
Hello All, I checked out the 356 site and could not find the info I need. Any other help would be great.
Thanks again Ron |
|
| r39o |
Fri Jan 05, 2007 1:16 pm |
|
If I recall, it is, most likely 4 mm hardware needed. Maybe 4 mm for the trim ring and 5 mm for the two mounting screws. You just need to look at one to see. No big deal here. They are held in place with regular screws, lock washers and nuts. No science to it. I have some in the garage I can look at, but seriously, it is not complicated. I forget, the hole size in the body for the bulb holder to stick throw. But using a caliper, it would take just a scant few seconds to figger it out.
Am I missing something here? |
|
| r39o |
Fri Jan 05, 2007 1:45 pm |
|
4 x 12 mm screw needed to attach the chrome bezel:
- A M 4x12 DIN 91-4 S
5 mm hardware to attach:
- M 5x20 DIN 84-5 S screw
- B 5 DIN 127 lock washer
- M 5 DIN 934-5 S nut
|
|
| rlmartinez |
Sat Jan 06, 2007 10:19 pm |
|
| Thank you r39o for the pics and info :D |
|
Powered by phpBB © 2001, 2005 phpBB Group
|