| [email protected] |
Sat Feb 01, 2003 3:53 pm |
|
i'm re-working my long panel right now on my 67, including welding in a new rocker. There was a shallow crease dent about 4" above the replacement rocker seam, which is causing some moderate oil-canning in about a 10" oval area. Aside from hammering in different spots, have been welding the rocker seam below and quenching it. This definitely causes the area to stiffen up, but the oil-can phenomena never completely goes away.
Any tips regarding this repair??
thanks tons...benfalia |
|
| TimGud |
Sat Feb 01, 2003 4:37 pm |
|
| Try a dolly and a shrinking hammer,just make sure you dont shrink it too much. |
|
| Kosmicride |
Sat Feb 01, 2003 7:40 pm |
|
| if you have a autobody nail gun try heating up around the oil can and in the middle this ususally takes care of the problem |
|
Powered by phpBB © 2001, 2005 phpBB Group
|