TheSamba.com :: View topic - need measurements for oval front windshield

Fri Jul 11, 2003 2:23 pm

i need someone to measure the front window from where the bottom of the lip where the cowl and dash are spotwelded together to the top where the rubber seals up i need the measurement taken in about the middle between the wiper shaft holes ,obviously this would have to be measured off someones project that has no window installed anyway if someone could do this it would be greatly appreciated i am installing a new front clip from window pillars foward cut a little above the upper heater vent ducts at A pillars and i want to make sure it fits correctly also if u have any tips please feel free to share them thnx

Fri Jul 11, 2003 9:55 pm

i need the verticle measurement

Sat Jul 12, 2003 7:31 pm

no one has a oval shell with no front windshield to get the measurement?

Sun Jul 13, 2003 4:01 pm

so just one measurement...right dead center.. from the bottom where the dash welds inside to the top where the seal lip starts? email me at www.joshmeacham@hotmail.com i don't understand "where' but i can do if for you and would be glad to help you out :D

Sun Jul 13, 2003 8:00 pm

you can email me as well for any additional measurements in that area just not front and rear as mine has been hit there.
vw4me@shaw.ca

Sun Jul 13, 2003 9:00 pm

ok thnx i sent a email to both of u
dave