| mrreddog |
Sun Mar 18, 2007 8:13 pm |
|
| i have a single port 1500 that im converting to a 1641 and want to go dual port, i was told the 2 inner case bolts need to be shorter on each side?? the existing bolts are i believe 9 mm. does anyone know where i can get these from? :? |
|
| mrreddog |
Mon Mar 19, 2007 11:35 am |
|
| or can i just cut the studs down a little? how much shorter are they? i have an idea, can someone with a dual port case thats apart take a measurement of all the case studs from the case to the tip. i think there is only 3 different lengths.......thank you very much :wink: |
|
| 2gr8dgs |
Mon Mar 19, 2007 6:09 pm |
|
| bottom row 8-1/8 to 1/4". top 2 outside 6-3/4 to 7/8" top inside 6-1/8 to 1/4". I would get at least 1 more persons measurements. good luck! |
|
| mrreddog |
Mon Mar 19, 2007 9:00 pm |
|
| now were gettin somewhere,...thanks 2gr8dgs, i really appreciate your help...anyone else want to confirm these numbers..... :lol: :lol: |
|
| mrreddog |
Mon Mar 19, 2007 9:24 pm |
|
| if those numbers are correct, it looks like just the 2 inner bolts need to be shorter.like i was told, and i think i can just cut em down a little and be fine..now i need a set of dual port heads?? anyone got some good used ones for sale before i order new ones?? :) |
|
Powered by phpBB © 2001, 2005 phpBB Group
|