MJKBugsandbuggies |
Thu Apr 05, 2007 4:58 pm |
|
I am building this buggy over in the Off Road Forum, thought you buggy guys would like to see my PRP Bench install...
Before - back ledge was way too high...
Cut out an area big enough to allow the seat drop down 8"...
Fabbed up a pan out of 14 ga...
After...
Perfect |
|
sandhopper |
Sat Apr 07, 2007 9:18 pm |
|
is this on a long pan or short ? I like the idea of the pan , but why not out of fiberglass ? |
|
lostinbaja |
Sun Apr 08, 2007 3:45 am |
|
You probably could have just flipped the fiberglass piece over and glassed it back in along with making some sides.
The steel insert should work just fine.
Jerry... |
|
MJKBugsandbuggies |
Sun Apr 08, 2007 4:57 am |
|
It's on a long body. You're both right, but I can weld a lot better than I can fiberglass. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|