myxomycota |
Sat Jan 12, 2008 4:44 pm |
|
I just blinged out my 1600 DP and got new wires...the old shroud had a metal thingie to hold the wires up off the cool tins, etc. but the new one does not. I have routed them so as to definitely not touch the exhaust manifolds but does it matter if they lay on the "cool tins" or on the intake manifold/top of the engine case? Will they melt? :roll: |
|
Dudbust |
Sat Jan 12, 2008 7:37 pm |
|
Should be fine..Mine are laying in about the same place and have not burned yet... |
|
myxomycota |
Sat Jan 12, 2008 7:41 pm |
|
Thanks I know that's a stooopid question but I really didn't know how hot it gets there...and I hate cable-ties cause they look like crap! :lol: |
|
RaythO |
Sat Jan 12, 2008 8:18 pm |
|
I got a set of black Empi wire separators that I`m not going to use, you want them? yours for the asking. |
|
myxomycota |
Sat Jan 12, 2008 8:52 pm |
|
Hey I got a "chrome" set that you can have since I went with 8mm wiring and they don't fit...lol. I think I am going to shave them a little to see if I can get them to work. Thanks anyway...really nice of you |
|
Powered by phpBB © 2001, 2005 phpBB Group
|