| 2type2 |
Sat Dec 28, 2002 4:44 pm |
|
| I pulled the dual webers off of the engine from my 66 westy, looked all over and cannot ID them ..no numbers anywhere! I am getting ready for either a shortblock or rebuild but will not be going dual carb, so the dual webers will be sold. The issue is which ones are they? There is a complete hex crossbar linkage and manifolds with it. Can I measure the throat to ID?TIA any advice.Paul |
|
| oilspot |
Sun Dec 29, 2002 9:52 pm |
|
| Measure the throat, that will let you know what you've got. |
|
| 2type2 |
Mon Dec 30, 2002 3:49 am |
|
| Thanks scudcruiser, but do measure the width of the throat diameter and just figure the millimeters such as if 40 or 42 mm ? |
|
| oilspot |
Wed Jan 01, 2003 8:58 pm |
|
| Your on the right track! |
|
Powered by phpBB © 2001, 2005 phpBB Group
|