| [email protected] |
Thu Feb 13, 2003 10:56 pm |
|
| i have a 72 rivera an i cant figure out how to get the high an low beams to work i ahve 2 brown wires that arent touching anything on the switch an when i put them on there an take one off the high beams work an vise versa..plus if any one could help me out email i have some questions about my carb. |
|
| Moby |
Fri Feb 14, 2003 3:02 pm |
|
| Take a look at the wiring diagram 72 on http://www.vintagebus.com/ The wiring colors and terminal designations sre clearly marked there. |
|
| toddgsanford |
Fri Feb 14, 2003 4:30 pm |
|
it is likely the ground in the switch is broken you can replace the switch or take it apart and solder the wire back in place be careful though as the solder some times melts the plastic and turns the switch to junk
todd |
|
Powered by phpBB © 2001, 2005 phpBB Group
|