| mvanpelt |
Wed May 28, 2008 7:09 am |
|
| Haveing problem keeping my rabbit running it seems to not want to start after it in the warm cycle. I pulled the injectors and looked at them two looked ok with pressure and cranking the engine the othe two are looking like they are slightly clogged I am replacing all 4 of them. The question is will I need to reset my mass air flow valve when I have completed the replacement?? |
|
| mike yapps |
Wed May 28, 2008 5:12 pm |
|
| Unless you've messed with it trying to figure out the problem, you shouldn't have to. |
|
| mvanpelt |
Fri May 30, 2008 9:26 am |
|
| Well, the truth be told I have recovered this rabbit from the grave... Its not ran in a few years I had to change, fuel :twisted: pump, filter, dist., and now injectors nedless to say I did have to move the adjustment just to get it to run. Now that its running when the engine is hot it hard to start , I think the dwell is what could be causing it ( its got to be a fuel or spark issue) normal process if one good then the other is not.... or it would run fine.. |
|
| dwilloughby |
Wed Jun 04, 2008 9:22 am |
|
| I had a similar problem with my Rabbit, it turned out to be the fuel pump relay. |
|
| mvanpelt |
Fri Jun 27, 2008 2:56 pm |
|
| It seems that this was not only problem the fuel pump relay was bad but the Fuel tank had rust in it... I found this out by removing the fuel lines at the filter to perform quality check. it passed but on the small side so i doubled it and it failed by removing the main line to the fuel pump for the tank and I had to push compressed air in to the tank to get fuel out of it... bad deal new tanks is here next it putting it in... |
|
Powered by phpBB © 2001, 2005 phpBB Group
|