THINGONER |
Tue Jun 03, 2008 8:03 pm |
|
I just searched the archives and have most of my questions answered. But I have a couple more regarding re-assembly of the stub axles. I have an o ring the same diameter as the stub axle and a shiny chrome washer (shim?) -I'm not sure where these should be placed. There is also a large o-ring which I assume goes around axle housing but not sure where? Any help would be greatly appreciated. |
|
Ian Epperson |
Wed Jun 04, 2008 2:43 pm |
|
I just did this a few months ago, took pictures and notes... but haven't yet posted them. I'll see if I can dig them up tonight.
The smaller O-ring holds the silver washer-shim-thing in place (don't remember where off the top of my head). The larger O-ring seals the cover after putting the backing plate back together (again, IIRC). |
|
THINGONER |
Sun Jun 08, 2008 11:31 pm |
|
Thanks. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|