| Buttafuoco |
Mon Jun 30, 2008 11:05 pm |
|
Will one more click down in the rear level out my red fasty or will it sag?
<---------------- |
|
| RafCarre12 |
Tue Jul 01, 2008 3:59 am |
|
Leave it alone... the slight rake is nice. |
|
| frank2 |
Tue Jul 01, 2008 8:01 am |
|
If you go one more click there wont be any susp travel left.Spring plate
banging on sub frame,(or start cutting).-Frank 8) |
|
| [VU]Juan |
Tue Jul 01, 2008 10:43 am |
|
You would be able to achieve an even ride height by adjusting the inner and outter splines, it would just take longer than just "going down 1 more click". You might have to go up 1 down 1, or up 2 down 2... you get the idea...
It also depends on how the car rides currently and how you want it to ride afterwards. If it already feels bad then going lower will just make it worse. |
|
| Slowlow |
Tue Jul 01, 2008 1:39 pm |
|
One more would look fine, but I think it would make the front look bad.
Right now you have an even wheel-fender gap and it looks good... I'd leave it alone. |
|
| Buttafuoco |
Tue Jul 01, 2008 3:36 pm |
|
| It actually rides quite pleasant considering a lot of the negative posts I read about going down 3 in the front. I think I'll leave it the way it is. Thanks guys!!! :D |
|
| kellydogg |
Thu Jul 03, 2008 10:08 am |
|
| Looks good as-is......I'm not a big fan of the whole draggin' ass look, so I'd leave it alone. Unless you mess around with the inners to make the rake a little less obvious.....just my .02, but looks great as-is...i'd leave it 8) |
|
| acetate909 |
Thu Jul 03, 2008 1:53 pm |
|
leave it looks great
:)
what are the specs on the lowering? how many clicks, inner/outer splines?
sorry im still trying to get all that stuff down :oops: |
|
| Buttafuoco |
Thu Jul 03, 2008 5:11 pm |
|
| I went 3 outter in front and 2 outter in rear. However, the previous owner may have had the rear down one spline making it sit a bit higher Reason I think this is when I disassembled the rear it was obvious that it had been taken apart at some point and while browsing through the samba's gallery a lot of Fastbacks that were down 2 in the rear seemed to be a bit lower/leveled. Just my guess though. But yeah 3 outter front, 2 outter rear. Hope this helped and good luck! |
|
| acetate909 |
Thu Jul 03, 2008 5:55 pm |
|
Buttafuoco wrote: I went 3 outter in front and 2 outter in rear. However, the previous owner may have had the rear down one spline making it sit a bit higher Reason I think this is when I disassembled the rear it was obvious that it had been taken apart at some point and while browsing through the samba's gallery a lot of Fastbacks that were down 2 in the rear seemed to be a bit lower/leveled. Just my guess though. But yeah 3 outter front, 2 outter rear. Hope this helped and good luck!
yes sir! :)
thank you kindly |
|
Powered by phpBB © 2001, 2005 phpBB Group
|