| sszuch |
Fri Jul 25, 2008 3:15 pm |
|
| When cutting pistons for valve pockets, what is the angle of the cutter relative to the piston? |
|
| 63single |
Fri Jul 25, 2008 5:11 pm |
|
I'm fairly sure the angle is 9° for a type 1 head.
Hope that helps. |
|
| A.J.Sims |
Fri Jul 25, 2008 5:50 pm |
|
| It will depend on the angle the heads are cut/built at but most from 9* to 9.5* for type 1 :D |
|
| sszuch |
Fri Jul 25, 2008 7:27 pm |
|
| Thanks guys! |
|
Powered by phpBB © 2001, 2005 phpBB Group
|