| purp72 |
Sun Aug 10, 2008 5:15 pm |
|
| where can i find them, i checked cip1, but i just need one clamp. will a large hose clamp do the trick? i'm not too serious about aesthetics. just my buggy running again and out of my driveway |
|
| mnussbau |
Sun Aug 10, 2008 6:04 pm |
|
| Are you referring to the clamp at the small end of the boot? I'd say a hose clamp would be fine, but if you have later-style axles there's an indentation where the small end sits and you don't need clamps at all. The boot provides a nice tight fit. |
|
| purp72 |
Sun Aug 10, 2008 8:59 pm |
|
| it was one of the large snap clamps with the tit on it.i the largest hose clamp i had was just a bit too small. |
|
| johneliot |
Sun Aug 10, 2008 9:11 pm |
|
Mike's right. You don't really need anything, but if you want something for piece of mind, just use a zip tie on it.
John |
|
| purp72 |
Wed Aug 13, 2008 6:39 am |
|
| it iis the clamp on the large end of the boot that connects to the cv joint cover. the small end never had clamps and IS a snug fit. so can i just use a standard hose clamp on the large end of the cv boot????? |
|
| johneliot |
Wed Aug 13, 2008 7:30 am |
|
The end that goes onto the cv joint is attached to the boot. It gets tapped onto the boot. The small end is the one that does/does not need a zip tie.
John |
|
Powered by phpBB © 2001, 2005 phpBB Group
|