| at0lde71 |
Mon Aug 11, 2008 9:30 pm |
|
I have the engine out and I am in the process of installing new tar board and was thinking about running a set of at least three wires from the engine bay to the front for future items such as a tachometer and other gauges such as oil pressure and temprature gauges. I noticed that the original wiring harness runs from the left side of the engine bay (facing the engine) inside the rear seat.
Does anyone know exaclty where this harness runs thru?
Will I need to remove the headliner and other uphosthely to runs those new wiring I want to run?
Thanks,
Antonio |
|
| at0lde71 |
Mon Aug 11, 2008 9:30 pm |
|
| Forgot to mention this is a 1971 standard beetle. |
|
| runamoc |
Tue Aug 12, 2008 6:50 am |
|
Quote: Does anyone know exaclty where this harness runs thru?
Will I need to remove the headliner and other uphosthely
In runs thru the spray foam stuff. Take a coat hanger and poke it through, then tape the wires to it and pull it in. You'll have to take off the rear driver side, umm 'door', panel to see the original harness and the coat hanger. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|