| xxbrandnew10xx |
Wed Aug 13, 2008 6:49 pm |
|
| last night i started putting my carbs and linkage back on my motor after it be down for awhile. anyways i never really noticed it before but now my linkage is crooked. the hex bar is noticeably angled. The kit is the redline linkage and its obvious one of the mounting plates are off set and im just wondering if this is to bad to run it like this i ran this linkage for almost two years and never had a problem but i dont remember it being this crooked. here are some pics EDIT working on pictures.... |
|
| Glenn |
Thu Aug 14, 2008 4:36 am |
|
| The cylinders are offset so unless you have "offset manifolds" to correct this, the linkage will be crooked also. |
|
| xxbrandnew10xx |
Thu Aug 14, 2008 9:00 am |
|
| thank you i was able to find some info on why the stuff was offset, thanks i have no idea if i have offset manifolds i figured it wouldnt be an issue because i bought the motor brand new and the builder would have fixed this but it seems that it works fine, i drove 30 miles round trip last night to make sure everything was working and everything worked perfect |
|
Powered by phpBB © 2001, 2005 phpBB Group
|