reluctantartist |
Mon Sep 01, 2008 5:15 pm |
|
I put on a new heater box (DansK) and noticed it doesn't have a drain hole like the factory one. Do I need have one as in... will the new heater box rust away faster as a result?
Thanks |
|
terryg |
Mon Sep 01, 2008 6:35 pm |
|
I'ld have to look to be sure, but isn't the outer shell made out of aluminum? Also would standing water be a problem if it can only get in there when the engine is running, and would be evaporated? The original hole may have been stress relief not drainage. |
|
M_atthewanderson |
Mon Sep 01, 2008 6:47 pm |
|
I do not know how important it would be for stress relief but mine has been more for standing oil :roll: |
|
Powered by phpBB © 2001, 2005 phpBB Group
|