TheSamba.com :: View topic

Fri Sep 05, 2008 7:33 am

Does anyone have a photo or can tell me how the assy goes together thru the hub. I have two races, one with a taper on one end, two bearings, two seals, and a sleve that goes in the middle of all of this. I know where the bearings go, but don't know about the two races. Thanks.

Fri Sep 05, 2008 8:44 am

http://www.thesamba.com/vw/forum/viewtopic.php?t=313956

Fri Sep 05, 2008 12:21 pm

I understand everything except the outer bearing and seal. I have the Eagle Performance 3x3 rear arms and have the aluminum hubs. If I press the outer bearing into the hub, the seal would be on the outside and there is no room for the seal to go in. I have Tatum rear disks and can't seem to figure out how the seal will seal. Am I missing a end cap that the seal rides in?

Sat Sep 06, 2008 1:40 am

Without a picture of what you've got, it's difficult to tell but it sounds like you're missing the end cap that the seal runs in.

These should be the same arms as yours but probably different brakes. The end cap is the black part bolted to the outside of the caliper mounting plate and you can see the seal and the outer spacer in it.

Sat Sep 06, 2008 7:56 am

Thanks, that is exactly what I am missing. Now I know what to go get.