| HeftySmurf |
Fri Sep 26, 2008 5:56 pm |
|
| Been working on the van a bit cleaning it up changed the side markers, rear tail lights and front turn signals. One problem is now I dont have any lights in the passenger side. I checked all the fuses... Where should I look? |
|
| Dogpilot |
Fri Sep 26, 2008 6:24 pm |
|
| First off, did you check to see if the lights have power on that side. Lots of the lighting issues are corrosion in the socket itself or the ground. A multimeter would go a long way here. Check and see if you have a decent ground, there is power to the socket and the connectors are clean and free of corrosion. Even the wires to the spade connectors corrodes inside the insulation. You may need to clip the wire down an inch or so to get to un-corroded copper. Again, only way to tell is with a meter or test light. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|