| Tbirdusa |
Sat Oct 25, 2008 7:26 am |
|
Got my new engine in and setup with 32 advance and the Weber 44's sync'd in.
2332, 42 x 37 mini wedge, E125 cam, 8.75:1 CR.
I'm looking for a bit of advice on jetting this engine. I haven't had it out of the garage yet but running in nuetral, it runs great. Very responsive once warmed up and no dropping cylinders at idle.
It's currently jetted with 50 idle, 150 mains, 200 airs.
How would I know if I've got a lean condition? Don't have a CHT gauge on it. |
|
| David Miskov |
Sun Oct 26, 2008 2:15 am |
|
vents?
e-tubes? |
|
| MURZI |
Sun Oct 26, 2008 2:25 am |
|
| With 36 vents and f11's i would bump the idles to 55's . On the mains, 150's should be real close....145's may make it run better. |
|
| SkrapMetal |
Sun Oct 26, 2008 2:53 pm |
|
Tbirdusa wrote: How would I know if I've got a lean condition? Don't have a CHT gauge on it.
Reading CHT is a very poor way of determining a lean condition. You really need a wideband to get it right. Most people are wayyy off in their tuning without even realizing it. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|