| Jeff Gill |
Sun Oct 26, 2008 6:57 pm |
|
| Witch intake is better for a single 44 idf ? the cheap looking chrome steel one or the aluminum one ? and what are the pros and cons of each (duals arnt an option rules say no) |
|
| vwracerdave |
Sun Oct 26, 2008 7:26 pm |
|
| What size engine? What heads and cam? What kind of racing? What vehicle? |
|
| Jeff Gill |
Sun Oct 26, 2008 7:33 pm |
|
| 1915 40x35.5 044 heads p&p 8.6 comp ratio 286 duration 473 lift its used in a 1400 lbs buggy the racing is in the woods with alot of low speed conditions I had to switch from duals to a single |
|
| SRP1 |
Sun Oct 26, 2008 7:50 pm |
|
| http://www.cbperformance.com/catalog.asp?ProductID=533 |
|
| vwracerdave |
Sun Oct 26, 2008 7:57 pm |
|
| 44IDF with 36mm venturies might be too big for a lot of low RPM. You may need to go down to 32-34 in venturie size and I would probably try the cheap chrome isolated runner intake. I hope you are not running larger then a 1 1/2" exhaust. |
|
| Jeff Gill |
Sun Oct 26, 2008 8:02 pm |
|
| no it has 1.5 tri-mill, and it does have 36 vents. I might try them and if I dont like it I can change them. I also have the chrome intake I just wanted other opions before I start fabing the header for the intake heat |
|
| gkeeton@zbzoom.net |
Mon Oct 27, 2008 10:34 am |
|
| The CB one, or the chrome one that has individual runners will work well. Some of the cast style ones have a hole connecting each intake runner in the middle, and sometimes makes the carb a PITA to get working well. Empi's 43-5208 Cast manifold has been modified to no longer have the connecting hole, so it would work well also. |
|
| Jeff Gill |
Tue Oct 28, 2008 3:12 pm |
|
| what would be a good baseline, jetting to get me started if I use 34 vents |
|
| westcoast-paul |
Tue Oct 28, 2008 3:46 pm |
|
Jeff Gill wrote: Witch intake is better for a single 44 idf ? the cheap looking chrome steel one or the aluminum one ? and what are the pros and cons of each (duals arnt an option rules say no)
Just raaazin you...
steel would allow more heat transfer - depending on where you want to use this (desert, iceland, etc)
If they are the same shape and length, i'd probably go for the aluminum one for weight and less heat transfer. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|