| Paul Wilson |
Sun Nov 16, 2008 10:39 am |
|
I have spent about 45 mins doing the search but didn't find the answer. I am building a stock single port engine using a new universal case. The top rear stud is deep set and the case has case savers for 8mm studs. Does anyone know of a source to get these studs?
Paul |
|
| Russ Wolfe |
Sun Nov 16, 2008 11:11 am |
|
| You should be able to get them from someone like CB Performance. |
|
| Paul Wilson |
Sun Nov 16, 2008 11:24 am |
|
Russ Wolfe wrote: You should be able to get them from someone like CB Performance.
I checked their site. Should I get the standard 8mm set and find longer one for the deep set #3? What length should the deep set stud be, for a single port head?
Thanks,
Paul |
|
| Russ Wolfe |
Sun Nov 16, 2008 11:34 am |
|
Call them and tell them what you have. They have an 800 number.
T-3 dual port and T-1 dual port use the same head studs.
I may even have a set out in the shop. |
|
| Russ Wolfe |
Sun Nov 16, 2008 11:41 am |
|
Yes, I have a set of those 8mm studs for the deep hole case.
Includes the nuts and washers. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|