| nodrenim |
Mon Nov 17, 2008 8:02 am |
|
| Does anyone out there have the following to share? I need a photo or drawing of the tool used to hook on the clutch release arm to pull the arm down to adjust the clutch cable easily. Also does anyone have a tech drawing of the shifter rod with the bushings shown? I would greatly appreciate any and all help given, Thanks! |
|
| Russ Wolfe |
Mon Nov 17, 2008 8:34 pm |
|
I don't have any trouble adjusting the clutch. Unless it is rusted up. The early cables just had a pair of hex nuts, and the later ones have a wing nut.
There is a clutch adjusting star that will fit both versions.
|
|
| nodrenim |
Tue Nov 18, 2008 11:14 am |
|
| Thanks Russ, I appreciate your help. I recently replaced my tranny and when I removed the cover at the end of the shifter, two pieces of what appeared to be a bushing, dropped out. I could not determine where they came from. I replaced the cover, sans the bushing, it seems to shift ok. I managed to get my old arthritic hands to function long enough to adjust my clutch. Thanks, again. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|