| P7rns |
Thu Nov 20, 2008 7:12 am |
|
| I have a 64 Split and intended to replace my leaky Pict 28 Carb with a new H30/31 brosol. however, the new carb doesn't fit the manifold. Is there an adaptor available to buy and where do I get one ? |
|
| BarryL |
Thu Nov 20, 2008 8:16 am |
|
| What doesn't fit, the spread of the 2 mounting studs? I thought those had the same spread as a 28. I've never seen a little-to-big adapter. I've seen people use a dual port intake center section and cut the single port ends off to use it for a 34 pict. Some dual port intakes have elongated holes so they fit 28 through 34s. |
|
| P7rns |
Thu Nov 20, 2008 9:17 am |
|
| yeah, its the studs on the bottom of the new carb, they are too far apart ! |
|
| ///Mink |
Thu Nov 20, 2008 9:50 am |
|
P7rns wrote: yeah, its the studs on the bottom of the new carb, they are too far apart !
Are you sure it's a 30/31 and not a 34? |
|
| PEPPE |
Thu Nov 20, 2008 4:34 pm |
|
| some (or maybe all) 30h31 come with an adaptor already installed. i just remove it and under there i find the standard 28-30-31 flange ready to install. |
|
| P7rns |
Fri Nov 21, 2008 4:52 am |
|
| Thanks Peppe, I really should have spotted that !!! |
|
Powered by phpBB © 2001, 2005 phpBB Group
|