| bigracedad |
Wed Jun 24, 2009 8:15 pm |
|
| were these only produced in the 4.5 et 46,, or did they come in a 5.5 also, and what number would that be.. |
|
| Neil Davies |
Thu Jun 25, 2009 5:39 am |
|
bigracedad wrote: were these only produced in the 4.5 et 46,, or did they come in a 5.5 also, and what number would that be..
Only 4.5J originally. Never seen any in 5.5J in 15 years! If you wanted a wider set I suppose you could have them re-rimmed? |
|
| bigracedad |
Thu Jun 25, 2009 6:25 am |
|
| I just wanted to make shure,,, I have 2 and if they made a wider wheel I would look for that |
|
| Bruce |
Fri Jun 26, 2009 11:02 pm |
|
| It only exists in 4½". |
|
| sharkskinman |
Thu Mar 11, 2010 12:21 am |
|
no the marathons were BUG offset but if your good you can find the Type 3 offset ones
type 1 offset in the front and type 3s in the rear would look good |
|
| Scott H |
Thu Mar 11, 2010 7:52 am |
|
Bruce wrote: It only exists in 4½".
I've got a set of 4.5" Marathons and the offset is 34mm. Were they also produced in a 46mm offset as stated by the OP and sharkskinman? |
|
| luckystiff |
Thu Mar 11, 2010 9:27 am |
|
sharkskinman wrote: no the marathons were BUG offset but if your good you can find the Type 3 offset ones
type 1 offset in the front and type 3s in the rear would look good
i think your backwards there. you'd run type 3 up front and type1 out back to get a staggered look. though it would only be like a 1/2"...ken.... |
|
| sharkskinman |
Thu Mar 11, 2010 10:24 am |
|
| yes... |
|
Powered by phpBB © 2001, 2005 phpBB Group
|