| Different Drummer |
Sat Jun 27, 2009 12:24 pm |
|
Did a search using "Ball Joint" But didn't find what I was looking for.
Can anyone supply the following information?
1) What are the part #'s for Type 181 ball joints
2) I understand that there are the "Good Ones" and the not as good ones. Who makes the "Good Ones" and where can I order them from?
3) Anyone drilled and tapped a ball joint or tie rod end to install a zerk fitting prior to install thus allowing periodic greasing? ( Old school guy here )
Thanks,
DD |
|
| [email protected] |
Sat Jun 27, 2009 7:14 pm |
|
181405361a upper
181405371 lower
just get a german brand, heyd or meyle
there is a divit on the top or side of the ball joint for a grease fitting |
|
| Different Drummer |
Sun Jun 28, 2009 5:49 am |
|
[email protected] wrote: 181405361a upper
181405371 lower
just get a german brand, heyd or meyle
there is a divit on the top or side of the ball joint for a grease fitting
Thanks for the Info.
DD |
|
| ud40 |
Sun Mar 25, 2012 12:38 pm |
|
| Does anyone know what tread size you would tap for a zerk fitting. I want to do that before I try and install new ball joints. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|