| sammyg |
Sun Sep 06, 2009 11:57 am |
|
| It seems that my front tires are rubbing so I'll for sure need a wider front end. I've searched hi and low, google and on here, and I can't find out how to widen them or what exactly goes into that front end. Steering, torsion bars, etc. Or even building my own from custom tubes. What are my choices? Is there a way to get lift too? Thanks |
|
| baja5 |
Sun Sep 06, 2009 12:53 pm |
|
| You didn't say if your car had a link pin or Ball joint front end, but the easiest and free way to get some lift is to cut and turn the front end. You cut the center sections out of the beam, where the grub screws are and turn them,then weld them back in. Or you can buy and weld in adjusters. Lift spindles are also an option. There are a few places that make them. |
|
| sammyg |
Sun Sep 06, 2009 1:20 pm |
|
Link/King front end, my bad. The arms seem to be resting on top of the bump stops already though. I'm not too concerned about lift, more so about widening the front beam. How would I do this?
Thanks |
|
| baja5 |
Sun Sep 06, 2009 1:27 pm |
|
| There are acouple of ways to widen it, you can find a donor beam and cut the center out of it in the width you want and weld it in. I have seen people weld in 2 adjusters per beam tube to add width also. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|