| Anchovy |
Thu Oct 08, 2009 11:31 am |
|
I have a set of NOS aluminum trim pieces and want to know which model they fit (I know nothing about 411/412's). On the box there is a hand written note: "Type IV four door". They look like the parts attached around the vents in this photo. I also have a few door edge trim sets. They look like they are for a 4 door model. Any information is appreciated:
|
|
| ubercrap |
Thu Oct 08, 2009 11:38 am |
|
| That vent trim should fit all 2 and 4 door sedans, all years 411/412 I believe. Door edge trim should fit all years 411/412 4 door sedan. |
|
| Anchovy |
Thu Oct 08, 2009 11:42 am |
|
| Thanks for the reply. I want to include the correct information when I post up an ad. Thanks again |
|
| segge |
Thu Oct 08, 2009 12:19 pm |
|
ammm... i'm interessted :)
in both parts ;)...i have a 4 door limo.... :P |
|
| Anchovy |
Thu Oct 08, 2009 8:21 pm |
|
The vents I have seem to have a slight curve to them and don't look as straight as the ones in the brochure image. Would these fit a different year? |
|
| ubercrap |
Fri Oct 09, 2009 5:24 am |
|
| I think it might just be the angle? I have a 411 engine lid on my one of my 412s. AFAIK, the only thing that was changed on the rear end over the years was the position of the tail lights and bumpers. |
|
| Anchovy |
Fri Oct 09, 2009 11:00 am |
|
Found this one in the gallery with the vent trim:
|
|
| ALLWAGONS |
Sat Jan 29, 2011 9:12 am |
|
I got this glove box divider. Is it rare?
|
|
| raygreenwood |
Sat Jan 29, 2011 11:51 am |
|
| I have never seen that glove box divider....cool! I have two sets of the vent trim in the boxes....but still really cool! Ray |
|
Powered by phpBB © 2001, 2005 phpBB Group
|