| andrewsanteiro |
Tue Oct 13, 2009 9:34 am |
|
I need a clutch kit. The car is a 72 sedan, the engine is, I don't know (bus i think). What I wasn't sure on is what measurement depicted the mm rating of what I need to install.
These are the measurements I got. In mm neither match up to anything I have seen. 8 3/32in = 205mm & 9 1/4in = 234mm roughly.
|
|
| turboblue |
Tue Oct 13, 2009 9:53 am |
|
That is a T-1 engine/flywheel or possibly an early bus, not likely though.
200mm disc and a late style pressure plate if you have the original transmission with the collar around the input shaft. |
|
| fusername |
Wed Oct 14, 2009 10:54 am |
|
| odds are any 200 mm clutch. a pic of the tranny can let you know if you need to remove the center ring or not. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|