| WHITEDESERTRACING |
Mon Oct 26, 2009 8:51 am |
|
Is it possible to use a weld-in tilt steering bracket with a disconnect coupler? Or does it have to be a straight shaft?
Thanks! |
|
| Mal evolent |
Mon Oct 26, 2009 9:06 am |
|
steering wheel is a splined shaft held on with one nut. you don't need no quick disconnect.
I plan on solving this problem with a 3" body lift. |
|
| joescoolcustoms |
Mon Oct 26, 2009 11:38 am |
|
WHITEDESERTRACING wrote: Is it possible to use a weld-in tilt steering bracket with a disconnect coupler? Or does it have to be a straight shaft?
Thanks!
It depends on where you are planning to put it on your steering shaft. It does need a straight part to twist in. If it is below your tilt, on a straight peice and above the steering box it can be done.
Take a picture or describe further what you are trying to do. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|