| Foster Folsom |
Wed Feb 10, 2010 11:51 am |
|
| I just installed an engine in my bus. It was a FI 75 and I changed it to a single carb. I am not getting any power to the new fuel pump and I was wondering where I should look Is there a relay that was part of the FI system that I removed if so where would I look? |
|
| busdaddy |
Wed Feb 10, 2010 12:00 pm |
|
If you are trying to use the FI pump wires to power the new low pressure pump nothings going to happen, the FI system controlled the pump.
You'll need to wire in a fuel pump relay like the ones Germansupply sells. |
|
| Foster Folsom |
Wed Feb 10, 2010 12:09 pm |
|
| yes I am trying to use the FI wiring. So can I wire a hot lead in and ground the pump lead or is the relay necessary? |
|
| Foster Folsom |
Wed Feb 10, 2010 12:59 pm |
|
| Thanks for the help I will order the relay (gave it some thought) |
|
Powered by phpBB © 2001, 2005 phpBB Group
|