| Stripped66 |
Mon Nov 02, 2009 6:05 am |
|
| Does anybody know the thread-pitch at the 'clutch-end' of a CNC slave cylinder? I need to replace the locking-nut because the nut against the throw-out arm keeps backing off. I can get a metric nut to catch a thread, but I can't tell if the pitch is standard, or if there is rust/oxidation preventing the nut from threading any further. Thanks! |
|
| turboblue |
Mon Nov 02, 2009 8:54 am |
|
| 5/16-24 |
|
| Stripped66 |
Mon Nov 02, 2009 10:32 am |
|
| Thank you! |
|
Powered by phpBB © 2001, 2005 phpBB Group
|