| shamill |
Wed Nov 25, 2009 10:19 am |
|
Ok, So last year a blew up my 091 so I decided to upgrade to a Mendeola 2D. Since doing this my CV's are clicking very bad. I left the Motor in the same spot and installed the trany via that location. My question is are the output shafts in the same location on the 091 and 2D. I would measure myself but sold the 091. Im guessing I am over exceeding the angles limits of my 930's now.... The up down angles is around 24d and the front back angle is around 15d.
HELP!!! |
|
| coolrydes |
Wed Nov 25, 2009 3:03 pm |
|
You have two problems:
1) too much angle in your cv's
2) the Mendeola box is not as wide as the bus box. So you'll probably need longer axles. |
|
| c jaklevick |
Wed Nov 25, 2009 5:25 pm |
|
| mendeola is about 1.75" narrower and the drive flanges are about t inch higher. when we switghed over last year i had the same problem with the race car. lost about 1 " of travel. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|