| laroche21 |
Mon Feb 08, 2010 4:33 pm |
|
| is their a way to test the electronic ignition module with a volt meter? |
|
| TomWesty |
Mon Feb 08, 2010 4:46 pm |
|
| I can't remember what terminals to hook to but the module is just a switch that is activated by a magnet. You can rotate the engine and or the distributor as though you are static timing your engine, and see if it switches on/off as the magnets on the rotor plate pass it. It should be switching 12v to the coil primary. Edited-look at rocketrod's response on your previous post. |
|
| laroche21 |
Mon Feb 08, 2010 5:26 pm |
|
| thank you |
|
Powered by phpBB © 2001, 2005 phpBB Group
|