| west coast ghia |
Mon Mar 01, 2010 1:52 am |
|
| will a bus shifter fit my 66 ghia mounting piont? im looking for a taller shifter for the look im going for. |
|
| sactojesse |
Mon Mar 01, 2010 6:19 pm |
|
Not sure about a bus shifter, but I'm partial to Hurst-style shifters. I'm using an original Hurst shifter in my ghia. The bent shaft models work best for ghias.
|
|
| 70 140 |
Mon Mar 01, 2010 6:39 pm |
|
| I think if you use a pre 67 type 2 shifter, the ball end that engages the shift rod is the same diameter. |
|
| west coast ghia |
Wed Mar 17, 2010 12:50 am |
|
sactojesse wrote: Not sure about a bus shifter, but I'm partial to Hurst-style shifters. I'm using an original Hurst shifter in my ghia. The bent shaft models work best for ghias.
i already have that hurst in my ghia just tring to complete a look |
|
| Greezy Joe |
Wed Apr 14, 2010 11:55 pm |
|
| The bus style shifter has a spring loaded pin that locates the ball into the socket on the shift rod. This keeps it from spinning around. If your shift rod socket has the slot in it it would work. Would be a little tall but that can be fixed. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|