| PaintingWithPressure |
Sat Mar 06, 2010 4:24 pm |
|
| what feeler gauge should i use to adjust valves on 1957" 1200cc ?? |
|
| PaintingWithPressure |
Sat Mar 06, 2010 6:58 pm |
|
| is it .001 on all ? or is it .002 for intake and .003 for exhaust ? |
|
| jerry.t |
Sat Mar 06, 2010 7:13 pm |
|
| ask your question in chat, thats where all the experts are... |
|
| johnshenry |
Sat Mar 06, 2010 9:41 pm |
|
I do .006" all the way around, although spec is .004"/.006" depending on what reference you are using. I'd rather have them a couple thou out than tightening up. Read the article on valve adjustments and why they are so important at my site thebughop.org if you are so inclined (in the Maintenance section).
Pay very close attention to #3 exhaust, check it often. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|