| mykpadilla@hotmail.com |
Fri Nov 22, 2002 6:43 pm |
|
| I hope someone can help. Will the front and rear apron of a 67 fit me 69? I compared my brothers 67 to mine and they seemed realy similar. Also is there a kit or something, or some way that a regular old Joe like me can repair the throttle housing on my 30 pict carb. The wholes on the housing have worn out pretty bad and I can't tune it right it is sucking in too much air. I would appreciate and suggestions. Thank you |
|
| chillz1 |
Sat Nov 23, 2002 2:48 am |
|
| I'm not positive about the apron issue, but as far as the carb goes, this is NOT a job the amatuer do-it-yourself type person wants to tackle. Re-bushing a carb is a precise and difficult job, best tackled by those with the appropriate equipment. http://www.rimcovw.com is one place that performs this service. If you arent particularly attatched to this carb, new ones are readily available for under $150.00 |
|
| chillz1 |
Sat Nov 23, 2002 2:49 am |
|
A direct link to the page where rimco discusses throttle re-bushing prices:
http://www.rimcovw.com/misc.htm |
|
| Adam Vegas JHC |
Sat Nov 23, 2002 6:45 am |
|
| a 30/31 is 115 bucks, I just put one on my car. Bolted it on, and it fired right up, no tuning needed.... |
|
Powered by phpBB © 2001, 2005 phpBB Group
|