| revfair@softcom.net |
Sat Dec 21, 2002 6:08 pm |
|
| I have an engle 120 cam and I am running chromoly push rods with lube-a-lobe lifters on cb big valve heads with Scat 1.25 rockers and lash caps. The engine has about 4000 miles on it though I bought it with 3000 on it and installed it in my bug. When setting the valve clearances I noticed that the number 1 cylinder valves are set to .004 with the engine at tdc for the number 1 cylinder but when the engine is at tdc for the number 4 cylinder the valve clearance on the number 1 cylinder changes to about .011. Is this normal or is my cam bad. Any info. would help. |
|
| BGEE68 |
Sat Dec 21, 2002 10:51 pm |
|
| Have you set the clearance on ALL the cylinders before you "found" this problem? |
|
| revfair@softcom.net |
Sun Dec 22, 2002 3:52 pm |
|
| Yes, I set the clearance on all of the cylinders before I noticed this. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|