| jason |
Sat Aug 31, 2002 4:58 pm |
|
| I wondered if anyone has the shim diagram for the link pins. The amount of shims to be used when setting up the geometry. |
|
| julesdalton@hotmail.com |
Sun Sep 01, 2002 4:58 pm |
|
Yes have table in a couple of workshop manuals, give us a couple of days to get back to you though
regards
jules |
|
| julesdalton@hotmail.com |
Mon Sep 02, 2002 2:59 pm |
|
Measure displacemant of lower eye.should be .28 +- .08
correct the error with .02 shims were
A = top inner
b = top outer
c = lower inner
d = lower outer
Displacement No of shims
A B C D
.20 1 7 5 3
.22 2 6 5 3
.24 2 6 4 4
.26 3 5 4 4
.28 3 5 3 5
.30 4 4 3 5
.32 4 4 2 6
.34 5 3 2 6
.36 5 3 1 7
as you can see each link has 8 shims
IF displacement is greater than .28
add shims to A from B & to D from C
Thus if less than .28 add shims to b from A
& to C from D
If this does not work. Remove torsion arms & check them.do not add extra shims..
Regards
Jules |
|
Powered by phpBB © 2001, 2005 phpBB Group
|