| jason |
Mon Nov 11, 2002 7:17 pm |
|
| I was wondering how the wiring harness is routed in the frame rail. I am trying to put one in a bus that has had it taken out. It has belly pans, it goes in the frame until the belly pans start. I am assuming that there is a pipe running down the frame. I have tried to run a fish wire down the frame but it stops. Any ideas |
|
| buster |
Tue Nov 12, 2002 4:31 pm |
|
| im not sure on your bus, cause mine doesnt have belly pans on it. but my cable is just ran down the outside of the beam secured with the orignal metel tabs. i dont know why it would be any differnt with yours. |
|
| jason |
Wed Nov 13, 2002 11:19 pm |
|
| It is actually sealed, the frame rails are covered by the belly pans. I thought that they were open on the ends but i can't get anything through. I've tried a fish wire, I can hear it moving around on the belly pan?????I thought maybe it was like a Ghia, the tube along the side. |
|
| Lind |
Thu Nov 14, 2002 12:33 am |
|
| on safari pan buses, there is a tube that the harness goes through. hopefully, that tube is still intact. what kind of wire are you tying to run trough it? I would use something substantial like a clutch cable. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|