| rmiller@apr.com |
Fri Dec 27, 2002 12:22 pm |
|
| I have read on other sites suggesting that really original looking belly pans are manufactured in Denmark. Anyone have the company or website info on them. Google was a bust! |
|
| Anders-DK |
Sun Jan 05, 2003 12:34 am |
|
Hi
Maybe you are lokking for this site.
http://www.jpgroup.dk/ |
|
| dougburgy@msn.com |
Tue Jan 07, 2003 10:49 am |
|
You don't have to go to Europe to get these. Kelly (a.k.a. metal wizard) makes these for model specific applications with proper pressings. My understanding is they are a bitch to put it as it requires overhead welding and a lot of it. Also, slight trimming to fit is required as is the case with any aftermarket sheet metal products.
Link below. After going to link, click on the "our parts" tab in left margin and go about half way down page. You can buy center or sides. Full set is 450.00.
Good luck on your project.
Doug
http://www.metwiz.com/ |
|
Powered by phpBB © 2001, 2005 phpBB Group
|