| guido |
Wed Jan 15, 2003 11:29 am |
|
| I just had a throwout bearing, bracket that hold throwout bearing, clutch, pressure plate and gland nut replaced in my 66 camper. After the repair a bearing noise was coming from the bell housing when I had the bus in gear and let out the clutch about half way. We took out the engine AGAIN a found that the throwout bearing seemed to have been hitting the pressure plate incorrectly. We replaced the throwout bearing. The bus is still making the same noise. Any help would be appreciated. |
|
| keifernet |
Wed Jan 15, 2003 9:09 pm |
|
| Are you sure of the Crosshaft bushings and the way it is centered in the bellhousing.... sounds like it is not "centered up" correctly.... did the busshing kit get replaced... and or/ correctly??? |
|
Powered by phpBB © 2001, 2005 phpBB Group
|