| JayC |
Thu Feb 09, 2012 5:38 pm |
|
I need a quick bit of advice.
I have the new inner bearing in place and the circlip. I have put the new seal in, but I am not sure how far in it goes?
Does it go flush with the top of the trailing arm or does it go down further and rest against the circlip? If it goes flush, I think there is a space between the circlip and the seal. Do you fill this gap with grease?
I read the posts from Fun_181 and MichaelB. Very helpful!
Thanks,
Jay |
|