| barndoormambo |
Thu Mar 01, 2012 9:32 am |
|
..so what are the options , now, for sourcing a front BD bumper ( small license plate gap)?
- find an OG one - VERY difficult & vastly expensive
- Gerson?
-???...what others?
all help/comment will be gladly received :wink: :D |
|
| streetwagens |
Thu Mar 01, 2012 9:54 am |
|
| Modify a later one, it's only a few more butt welds. 8) |
|
| barndoormambo |
Thu Mar 01, 2012 9:59 am |
|
streetwagens wrote: Modify a later one, it's only a few more butt welds. 8)
..ok, explain- i have thought about this & i'd like to know how its done.. :? :D |
|
| streetwagens |
Thu Mar 01, 2012 10:44 am |
|
| Fabricate 2 short lengths of the 'raise', then cut the curved edges out of the centre of the bumper and move them in by the right amount to give the smaller gap, then weld the fabricated bits in the holes left on the raise. :wink: |
|
| barndoormambo |
Thu Mar 01, 2012 10:57 am |
|
..cheers, Dude- i had that ....
its just the "Fabricate 2 short lengths of the 'raise'" catch that stumped me.. :roll: |
|
| streetwagens |
Thu Mar 01, 2012 11:00 am |
|
| Were you ending up with a short bumper? :lol: |
|
| barndoormambo |
Thu Mar 01, 2012 11:34 am |
|
streetwagens wrote: Were you ending up with a short bumper? :lol:
..yuh- it was kinda huggy.. :wink: |
|
| barndoormambo |
Thu Mar 01, 2012 11:36 am |
|
barndoormambo wrote: ..cheers, Dude- i had that ....
its just the "Fabricate 2 short lengths of the 'raise'" catch that stumped me.. :roll:
& i MEANT fabricating 2 short lengths of the raise might be the stumbling block! :shock: :roll: |
|
Powered by phpBB © 2001, 2005 phpBB Group
|